How To Install Furniture Locks

Oct 17, 2026

Leave a message

The installation process varies by lock type, but even beginners can complete the task by following these steps-just be sure to watch out for common pitfalls.

 

Preparation
‌Tools Needed‌: Power drill, appropriate wood-boring hole saw, Phillips/flathead screwdrivers, tape measure, pencil, and a wood chisel. For drill-free (adhesive) models, you will only need a screwdriver and the included adhesive pads.
‌Pre-installation Check‌: Ensure all lock components are present. Test the lock several times with the key to confirm that the internal mechanism operates smoothly without sticking.
‌Positioning‌: For drawer locks, aim for a spot 200mm from the top edge of the drawer. For standard cabinet door locks, position the lock between 900mm and 1050mm from the floor.

 

Step-by-Step Installation for Common Locks
1. Standard Drawer Locks
Drill a hole through the drawer panel at the marked center point. Using the center line of the lock cylinder as an axis, outline the required position and depth for the lock housing and backplate.
Use a handsaw to make cuts on the inner side of the drawer panel, then use a chisel to remove the excess material, creating a recess for the lock housing and backplate.
Insert the lock body into the recess and secure it firmly to the panel from the inside using screws. Ensure the lock body sits flush against the drawer surface with no gaps that could be pried open.
2. Drill-Free (Adhesive) Locks
Clean the mounting surface on the cabinet with alcohol and let it dry completely. Remove the protective film from the adhesive backing on the lock.
Align the lock with your pre-marked position and press firmly for 30 seconds. Allow it to set for 2 hours so the adhesive can fully cure, then attach the strike plate (latch) and test the opening and closing mechanism.

Send Inquiry